Samsung M017f Isp Pinout Page

If you see No eMMC found or CMD timeout, recheck your CLK and CMD solder joints.

While PCB revisions vary, the M017F layout generally follows this proximity:

(Note: Professional tools like Easy JTAG Box or UFI often have diagrams in their software interface if you search for "SM-M017F". Always cross-reference with a software diagram before soldering.) samsung m017f isp pinout

Power the board from the battery and measure voltages on suspected VCC/eMMC_VCC pads (do not probe eMMC data lines with power applied unless required).

Use a logic probe or oscilloscope while booting to locate eMMC_CLK and CMD (clock is periodic).

Confirm UART by connecting TTL serial (3.3V) to suspected TX/RX pins (RX to TX, TX to RX) and watching boot logs at common baud rates: 115200, 1500000, 921600, 57600.

To force ISP/EDL, locate and short BOOT_EN/test pad to GND or VCC per community-documented method for the model (confirm before attempting).

ISP is useless without a full firmware dump. For SM-M017F, look for: If you see No eMMC found or CMD

Extract the super.img and vendor.img along with preloader_m017f.bin from stock AP_*.tar.md5 files. Use MTK META Utility or SP Flash Tool compatible scatter files – but remember, ISP replaces the need for SP Flash Tool. While PCB revisions vary, the M017F layout generally

Samsung M017f Isp Pinout Page

Footer