Q: I saw a YouTube video showing 120 channels on a Midland 75822. Is it fake? A: Probably yes, or the video shows a different radio model mislabeled. Some creators use frequency generators to fake the display. Real-world results rarely match the hype.

Q: Can I just add a toggle switch to get "extra channels"? A: On older, simpler CBs (like the Cobra 29), yes. On the 75822’s surface-mount board, it is extremely difficult and unrewarding.

Q: What does “channel 41” get me? A: 27.415 MHz. You’ll find a few freebanders, occasional foreign truckers, and mostly noise. Emergency services don’t monitor it. You gain nothing useful.

Q: Will the mod improve range? A: No. Range is determined by antenna, line-of-sight, and transmit power (still 4W max). Mods reduce efficiency, so range decreases.

Q: Is there a software mod (firmware) for the 75822? A: No. The radio is not field-upgradable via USB. All mods require hardware changes.

The stock Midland 75822 is a Phase-Locked Loop (PLL) synthesized radio. The "channel mod" refers to altering the PLL’s feedback loop or switching mechanism to unlock frequencies outside the standard 40 channels.

Most Midland 75822 mods focus on adding 3 "bands" or "selectors" :

In total, a successful mod can turn your 40-channel radio into a 120-channel or even 160-channel monster.

For an individual off-roader operating occasionally? Rare. But if you cause harmful interference to a local fire department or aircraft, direction-finding teams can locate you within minutes. CB freeband (27.5-28.0 MHz) is also heavily used by 10-meter amateur radio operators, who won’t hesitate to report illegal transmissions.

Bottom line: Operating a modified 75822 outside the CB band makes you a pirate operator under international telecommunications law.

⚠️ WARNING: This guide is for educational purposes only. Attempting this modification may violate FCC regulations (47 CFR Part 95), void your warranty, damage your radio, and result in illegal operation. Proceed at your own risk.

If you still choose to proceed, here is the common method described in online forums:

Near the PLL chip, you should see a small grid of diodes or empty solder pads labeled something like "CH1, CH2, CH4, CH8" – these are binary weighting pins (1, 2, 4, 8). There may also be a "Band A/B" pad.

The PCB traces on handheld CBs are delicate. Excessive heat from soldering can lift pads. One wrong diode placement can short the PLL, causing the radio to transmit dead air—or nothing at all.

Verdict from experienced techs: The Midland 75822 channel mod is largely a myth for most production runs. The few who claim success likely own an early prototype or a different radio altogether (e.g., the Midland 1001Z, which is more mod-friendly).