Hw 130 Motor Control Shield For Arduino Datasheet [ Quick FULL REVIEW ]

Connect:

Control via:

Would you like a schematic diagram, a library usage guide, or a stepper motor example for this shield? hw 130 motor control shield for arduino datasheet

---

Pros:

Cons:

| Motor | Direction Pin (Arduino) | PWM Speed Pin (Arduino) | |-------|------------------------|-------------------------| | M1 | D12 | D5 | | M2 | D11 | D6 | | M3 | D8 | D9 | | M4 | D7 | D10 |

Connector Map:

Servo voltage selection – Jumper selects servo VCC from 5V (Arduino) or VS (external).

⚠️ Warning: Do not exceed 12V or 600mA per channel continuously.

The HW-130 allows you to control two DC motors or one stepper motor. It uses the L298P driver chip, which is mounted on the shield to handle the high currents that the Arduino cannot handle directly. Connect: