Heidenhain Itnc 530 Error List

The Symptom: The axis moves toward the reference cam, hits the cam, but instead of finding zero, it alarms out. The Cause: This is often a "dirty scale" issue. Heidenhain uses glass scales for feedback. If oil mist or coolant has contaminated the scale, the control loses the reference mark signal. The Fix:

  • Solution:

  • CE2: Incorrect axis offset - This might be due to incorrect settings in the axis offset configuration.

  • CE3: PLC watchdog error - This can be caused by PLC (Programmable Logic Controller) issues.

  • CE4: Data transfer error - This could occur due to issues with transferring data to or from the control. heidenhain itnc 530 error list

  • CE5: Incorrect configuration - This error might arise from incorrect system configuration settings.

  • ERR 1: Path error - Indicates a problem with the programmed path.

  • ERR 2: Syntax error - A syntax error in the NC program. The Symptom: The axis moves toward the reference

  • ERR 3: Parameter error - Incorrect parameter setting.

  • ERR 4: Limit switch error - A limit switch has been activated, or there's a problem with the limit switch circuit.

  • ERR 5: Emergency stop - The emergency stop button has been pressed. Solution:

    • The Heidenhain iTNC 530 is a powerful, widely used CNC control, but there is no single, official, complete “error list” in plain text. Instead, error information is distributed across:

    The Symptom: Usually occurs during a tool change. The machine thinks the tool is still clamped when it should be unclamped, or vice versa. The Cause: The drawbar sensors (two proximity switches usually) are not signaling the PLC correctly. This could be hydraulic pressure loss, a broken belleville washer stack in the spindle, or a stuck sensor. The Fix:

    Some errors indicate hardware failure beyond typical operator level. Call for professional service if you see:

    | Error code | Typical meaning | Fix | |------------|----------------|-----| | NC 1002 | Axis not traversable (interlocked) | Reset PLC, check safety door, reference point | | NC 1008 | Illegal coordinate / dimension | Check block format (L X+... R0 F...) | | NC 1100 | Unknown word / identifier | Typo in Q parameter, cycle, or variable | | NC 1200 | Program not found | Check program name / path | | NC 1250 | Block not permitted in this mode | Cycle called incorrectly |