Cartoonize AI

Emax Es08ma Ii Datasheet May 2026

  • Speed:
  • Deadband: ~5–10 µs (typical for analog micro servos)
  • Connector: Standard 3-pin JR/SR female (servo lead with female housing: Signal, V+, GND)
  • Operating temperature: -10°C to +50°C (typical hobby servo range)
  • Bearing type: Single ball bearing or bushing (depends on batch)
  • Gears: Metal gears (improved wear resistance vs. plastic gears)
  • Mounting: Standard micro-servo mounting tabs (2 screws)
  • Accessories: Set of plastic horns, mounting hardware, lead wire (usually 200–300 mm)

    • Notes: Values above are typical ranges reported across EMAX ES08MA II product listings and hobbyist testing. Exact figures depend on production batch and testing method.

    Critical Note for Builders: Do not power this servo directly from an Arduino or Raspberry Pi 5V pin. The stall current over 1A will brown out your microcontroller. Use a dedicated 5V UBEC (Battery Eliminator Circuit) or servo driver board with external power. Emax Es08ma Ii Datasheet

    #include <Servo.h>

    Servo myServo;
    

    void setup() 
myServo.attach(9); // Signal on pin 9
// The Servo library automatically uses 5-10 microsecond dead band
 Speed:
    

    void loop() 
myServo.write(0);   // 1.0ms pulse (CCW)
delay(1000);
myServo.write(90);  // 1.5ms pulse (Center)
delay(1000);
myServo.write(180); // 2.0ms pulse (CW)
delay(1000);
 Deadband: ~5–10 µs (typical for analog micro servos)