Top: Dcunlocker Commands List

Related search suggestions will be generated for further reading.

The DC-Unlocker client features a terminal window at the bottom of the interface where you can manually enter AT commands

to manage Huawei and ZTE modems. These commands allow for fine-tuning, changing network modes, or manually entering unlock codes when automated detection isn't enough. Essential DC-Unlocker AT Commands Action / Purpose AT^CARDLOCK? Checks if the modem is locked. Result means it's unlocked; means it's locked. AT^CARDLOCK="CODE" dc-unlocker-cli --login --password --credits

Manually enters the 8-digit unlock code (NCK) into the modem. AT^CARDUNLOCK="MD5"

Resets the NCK entry attempts back to 10 if you have previously exceeded them. AT^GETPORTMODE Displays the modem's current active ports and modes. AT^SETPORT? Displays the device's current port configuration. Reboots the modem to apply changes. Network and Hardware Mode Commands

These commands are often used to force a modem to stay in a specific network mode or disable unwanted virtual drives. Network Mode Selection ( AT^SYSCFG=13,0,3FFFFFFF,2,4 GPRS/EDGE (2G) AT^SYSCFG=14,2,3FFFFFFF,2,4 AT^SYSCFG=2,2,3FFFFFFF,2,4 — Preferred 3G mode. Modem Functionality ( AT^U2DIAG=0 — Modem mode only (disables virtual CD-ROM/SD card). AT^U2DIAG=1 — Modem + CD-ROM mode. AT^U2DIAG=255 — Default mode (Modem + CD-ROM + Card Reader). HSPA Settings — WCDMA mode. — HSDPA mode. — HSPA mode. — HSPA+ mode. Common ZTE Status Commands dc-unlocker-cli --login --password --info-dev --model

For ZTE devices, standard GSM AT commands are often used to check the environment: SparkFun Electronics : Checks the status of the SIM PIN. : Shows the currently selected network operator. : Checks the signal quality (RSSi) of the connection. SparkFun Electronics Always ensure your device is properly detected (using the magnifying glass

This report is designed for technicians and advanced users who utilize DCUnlocker for unlocking modems, routers, and phones. The commands are executed via the DCUnlocker CLI (Command Line Interface), typically found in the directory where the software is installed.

sudo mount -o loop /mnt/bitlocker/dislocker-file /mnt/decrypted