B- | Ccna-2v7.0 Case Study -rev
Installation File for Synchro Studio with Warrants and TripGen
B- | Ccna-2v7.0 Case Study -rev
The first section of the case study focuses on Layer 2 readiness. Misconfiguring VLANs here will cascade into routing and security failures later.
A small company, Clearview Media, has acquired a second office. You are assigned as the network engineer to design, implement, and verify the new branch network and ensure connectivity to the corporate headquarters via a serial WAN link. The network must support three departments (Sales, Engineering, and HR), provide secure access to printers and servers, and allow remote administration from headquarters. The network should be segmented using VLANs, use inter-VLAN routing on a router-on-a-stick, implement OSPF for dynamic routing with HQ, provide NAT for Internet access, secure management via SSH and access lists, and supply DHCP for hosts.
If you are currently working on this case study, here is a breakdown of the typical tasks involved in Rev B so you can verify your work:
1. Addressing Table Design
2. VLAN Configuration
3. Inter-VLAN Routing
4. Services (DHCP/SSH)
5. Verification
Note on Versions:
The CCNA-2v7.0 Case Study (Rev B) requires configuring a multi-site network for the Carl I. Samson Company (C.I.S. Co) following an acquisition, focusing on integrating Bangor, Phoenix, and Chicago locations. The project mandates implementing IPv4/IPv6 addressing, static routing, VLANs, switchport security, and DHCP services across the infrastructure. Detailed project requirements can be found at Course Hero.
Solved CCNA-2v7.0 Case Study (Rev B) Static Routes, VLANs
It looks like you’re looking for a proper guide for the CCNA v7.0 (2.7.0) Case Study – Revision B.
First, a quick clarification:
The official Cisco NetAcad curriculum for CCNA 2 v7.0 (Switching, Routing, and Wireless Essentials) includes several Case Studies depending on the instructor or region — but the most common “Rev B” case study focuses on multi-switch configuration, VLANs, trunking, STP, EtherChannel, and inter-VLAN routing, often using Packet Tracer. ccna-2v7.0 case study -rev b-
Below is a structured guide to complete the standard CCNA 2 v7.0 Revision B Case Study successfully.
If you want, I can produce:
The first critical task in the case study is dividing the broadcast domain using Virtual Local Area Networks (VLANs). VLANs improve security and reduce unnecessary traffic. Typically, Rev B specifies VLANs for different departments such as:
On each switch, VLANs are created using the vlan vlan-id command followed by a descriptive name. Access ports are then assigned to these VLANs using switchport mode access and switchport access vlan vlan-id. This segmentation ensures that broadcast traffic from Sales does not reach Operations, thereby improving performance and security. The first section of the case study focuses
Installation Requirements
- Itanium Processors are not supported.
- Setup program must be run with administrative privileges.
Prerequisites
Prior to installation all users must have;
Internet Explorer (Edge is an acceptable, too)
The following prerequisites are only needed for 12.2.4 and below:
Microsoft Visual C++ 2015-2022 Redistributable (x64) 14.40 or later*
Microsoft Visual C++ 2015-2022 Redistributable (x86) 14.40 or later*
* If .NET and C++ redistributables are not found during installation, they will be automatically installed and a reboot will be required after each installation.
