While aerospace has its own strict specs (AMS), secondary structural brackets and landing gear test fixtures often reference AISI D10017 for cost-effective material verification.
If you are writing a quality manual, purchase order, or inspection report, proper citation is essential. Use the following format:
Reference: AISI D10017-20XX (Year of issue). "Standard Practices for Cold-Finished Steel Bars." American Iron and Steel Institute, Washington, D.C.
On a purchase order, you might write:
"Steel bars shall conform to AISI D10017, latest revision, for straightness per Table 3 and diameter tolerance per Table 1."
Critical note: Always include the year of revision. A 1998 D10017 and a 2020 D10017 may have different tolerance bands due to modern mill capabilities.
First, it is essential to understand the naming convention. AISI (American Iron and Steel Institute) is a renowned trade association that has historically established many standards for the steel industry, including the famous SAE/AISI steel grades (e.g., 1018, 4140, D2 tool steel). aisi d10017 pdf
The code D10017 typically refers to a specific internal technical document, a testing methodology, or a material specification sheet rather than a broad "grade" of steel. Unlike standard AISI 4140, which is a chromium-molybdenum alloy, D10017 is generally understood within the industry as a document identifier covering:
It is critical to note that AISI D10017 is not as universally cited as ASTM or ISO standards. However, it remains a critical reference in legacy systems, supply chain contracts, and older manufacturing plants, especially those with deep roots in North American steel protocols.
If you have landed here searching for "AISI D10017 PDF", you are likely looking for a technical data sheet, material safety data sheet (MSDS), or a certificate of compliance for a specific metal product. However, there is a critical detail to understand first: While aerospace has its own strict specs (AMS),
"AISI D10017" is not a standard grade designation within the American Iron and Steel Institute (AISI) classification system.
Standard AISI grades follow clear patterns (e.g., 1018, 4140, D2, H13). The alphanumeric string "D10017" does not match any known carbon, alloy, tool, or stainless steel grade.
General rules about burrs, end cuts, and twist in hexagonal bars. It also covers permissible straightening marks. Reference: AISI D10017-20XX (Year of issue)
One of the most referenced sections. It details acceptable levels of seams, laps, and pits. For example, it provides depth limits for surface discontinuities based on bar diameter.
Sharp corners are stress risers. This section defines allowable corner radii (rounded edges) for non-round shapes.